Installation guide

8 Wireless Network Installation
9. When you see a screen like this one, verify that the settings are correct. If you
need to change a setting, press
y Back until you see the setting you need to
change.
10. Once you have verified that your network settings are correct, press
OK to save
the settings and return to the Network Settings menu.
11. Press the
Home button to exit the Network Settings Menu.
12. Wait for the printer to connect to your wireless network (this can take up to
90 seconds).
Once it’s connected, you see the WiFi icon and a signal strength indicator
on the printer’s control panel.
13. Continue with “Install Software” on page 24.
Note:
If the printer doesn’t connect to your wireless network after 90 seconds, the WEP key
or WPA passphrase may have been entered incorrectly. See “Connect Wirelessly Using
the Setup Wizard” on page 5 to select your network settings again.
If the printer still doesn’t connect to your wireless network, see “The printer cannot find
or connect to the wireless router or access point” on page 31.