User`s guide

56 Transporting the Transparency Unit
4. Turn the transportation lock at the back of the scanner to the locked position.
Transporting the Transparency Unit
After you’ve removed the transparency unit from the scanner, prepare it for shipping
as follows:
1. Turn the transparency unit so the glass side faces up.
2. Use a Phillips head (cross head)
screwdriver to remove the
shipping screws from the
storage holes.
3. Install the screws into the
shipping holes (the outer holes).
If you are using a transparency unit and it is switched on, the scanner
carriage will not move to the home position. Remove the transparency
unit first, then perform the steps above. See the next section for
instructions.
Locked position
Storage holes
1640XL.book Page 56 Wednesday, November 19, 2003 8:46 PM