Owner's Manual
Table Of Contents
- User Guide
- Table of Contents
- Supplied Accessories
- Parts & Controls
- Introduction to Your Projector
- Setting Up the Projector
- Using the Projector on a Network
- Wired Network Projection
- Wireless Network Projection
- Selecting External Network Detection Settings
- Using Basic Projector Features
- Turning On the Projector
- Turning Off the Projector
- Viewing 3D Images
- Selecting the Language for the Projector Menus
- Adjusting the Image Height
- Adjusting the Image Position Using Lens Shift
- Image Shape
- Resizing the Image with the Zoom Feature
- Focusing the Image with the Lens Button
- Remote Control Operation
- Selecting an Image Source
- Projection Modes
- Image Aspect Ratio
- Color Mode
- Adjusting Projector Features
- Using WirelessHD
- Adjusting the Menu Settings
- Maintaining and Transporting the Projector
- Solving Problems
- Projection Problem Tips
- Projector Light Status
- Solving Image Problems
- Solutions When No Image Appears
- Solutions When "No Signal" Message Appears
- Solutions When "Not Supported" Message Appears
- Solutions When Only a Partial Image Appears
- Solutions When the Image is Not Rectangular
- Solutions When the Image Contains Noise or Static
- Solutions When the Image is Fuzzy or Blurry
- Solutions When the Image Brightness or Colors are Incorrect
- Solutions When a 3D Image Does Not Display Correctly
- Solutions When a WirelessHD Source Does Not Display Correctly
- Solving Projector or Remote Control Operation Problems
- Solutions When Wireless Authentication Fails
- Where to Get Help
- Technical Specifications
- Notices
- Quick Setup
- Warranty
89
Using WirelessHD
You can use the included WirelessHD transmitter to wirelessly stream HD content from a video device to
the projector (PowerLite Home Cinema 5040UBe).
WirelessHD Transmitter Parts
WirelessHD Transmission Range
WirelessHD Remote Control Operation
Connecting the WirelessHD Transmitter
Viewing WirelessHD Content
Switching WirelessHD Sources
WirelessHD Transmitter Parts
Front
1
power button (turns the transmitter on or off)
2 Input button (cycles through image sources)
3 WiHD/Pass button (cycles output signal between the projector and a display device connected to
the transmitter's HDMI Out port)