User`s guide

Using the Projector on a Network 83
Removing the Wireless LAN Module
Follow these steps to remove the module from your projector.
1. If you’re running NS Connection, click
Disconnect on the
control bar.
2. Check the access light to make sure it isn’t flashing.
3. Turn off the projector and unplug it.
4. Open the air filter cover by sliding the switch and pulling down
the cover.
5. Unscrew the module, then pull it out.
6. Close the air filter cover.
Click
Disconnect
caution
Never remove the module
while the indicator light is
green or when projecting
wirelessly. You may damage
the module or lose data.