User`s guide

Fine-Tuning the Projector 101
■ Operation
Use this menu to enable the following functions:
Direct Power On to have the projector start when the power
cable is connected (without pressing the
Ppower button).
Sleep Mode to have the projector turn off automatically if it is
idle (and no signal is received) for the amount of time you select
as the
Sleep Mode Timer (1 to 30 minutes).
Lens Cover Timer to have the projector turn off automatically
after 30 minutes when the A/V Mute slide is closed.
High Altitude Mode to increase cooling when you are using the
projector above 4900 ft (1500 m).
■ Standby Mode
Select Communication On to enable the projector to be
monitored over a network when it is in standby mode (the power
light is orange).
■ Standby Microphone
When the Standby Mode is set to Communication On, you can
set Standby Microphone to
On. This allows you to use a
microphone connected to the projector even in standby mode,
when Power On Protect is off.
■ USB Type B
Select USB Display to project your computer’s display through
the projector’s USB Type B port (see page 41). Choose
Wireless
Mouse
to use the remote control as a wireless mouse when your
computer is connected to the
Computer1 or Computer2 port;
see page 42.
■ Language
Select the language to be used for the projector menus.
note
If Direct Power On is
enabled, the power cable is
connected, and a power
outage occurs, the projector
will start when the power is
restored.
Do not use the projector at
altitudes above 7500 ft
(2,286 m).