Specifications

Rev. A Installation 2-7
UB-E02 Technical Reference Guide
2.8 FAQ
2.8.1 Q1. The printer does not operate correctly. ("Serial interface" is printed by
the self test for the printer.)
2.8.1.1 A1. For TM-T90, TM-L90, TM-J2000, TM-J2100, TM-J7000, TM-J7100, TM-J7500, and
TM-J7600, set the #25 pin reset signal of the Memory switch set to disabled. For other
models, use the printer with the #31 pin reset signal of the DIP switch for parallel interface
enabled.
2.8.2 Q2. The self test does not operate correctly.
2.8.2.1 A2. Turn on the printer power while pressing the FEED button and hold the Feed
button until printing starts to perform the self test for the printer with the UB-E02. Printing
starts in
approximately 6 seconds when the IP address is fixed or approximately 13
seconds when the IP address is acquired by auto setting. (It can be longer, depending
on the reply time of the host.)
2.8.3 Q3. Starting up the printer takes a long time.
2.8.3.1 A3. When the auto setting is set for IP address acquisition without a DHCP server,
starting up the printer takes about one minute. During this time, the self test for the printer
is not performed. Set the manual setting for IP address acquisition where the DHCP server
is not available.
Model Setting
TM-U200 Series DIP SW 2-8: ON
TM-U210 Series DIP SW 2-8: ON
TM-U230 Series DIP SW 2-8: ON
TM-U325 Series DIP SW 2-8: ON
TM-U590 Series DIP SW 2-8: ON
TM-U675 Series DIP SW 2-8: ON
TM-T88/T88II/T88III DIP SW 2-8: ON
TM-T90 MSW 1-8: ON
TM-H5000/H5000II DIP SW 2-8: ON
TM-H6000/H6000II DIP SW 2-8: ON
TM-J7000/J7100 MSW 1-8: ON
TM-J7500/J7600 MSW 1-8: ON
TM-J2000/J2100 MSW 1-8: ON
TM-L90 MSW 1-8: ON