Specifications

Rev. A Command Reference 3-5
TM–U950/U950P Information Manual
Mechanism control
commands (continued)
ESC q
Release Mechanical extension
GS V
Cut paper Mechanical extension
Panel button
commands
ESC c 5
Enable/disable panel buttons Hardware extension
O
ESC c 6
Enable/disable on-line switch Hardware extension
MICR commands
FS a 0
Read check paper Mechanical extension
●
FS a 1
Load check paper to print
starting position
Mechanical extension
●
FS a 2
Eject check paper Mechanical extension
●
FS b
Request retransmission of check
paper reading result
Mechanical extension
●
FS c
MICR mechanism cleaning Mechanical extension
●
Miscellaneous function
commands
DLE ENQ
Real-time request to printer Software extension
O
ESC @
Initialize printer Basic single
O
ESC =
Select peripheral device status Software extension
O
ESC L
Select page mode Software extension
ESC S
Select standard mode Software extension
ESC p
Generate pulse Hardware extension
O
FS L
Select double-density page
mode
Software extension
GS <
Initialize printer mechanism Mechanical extension
GS A
Adjust label position to start
printing
Hardware extension
GS C 0
Select counter print mode Software extension
GS C 1
Select count mode (A) Software extension
GS C 2
Set counter Software extension
GS C ;
Select count mode (B) Software extension
GS E
Select print speed and head
energizing time
Hardware extension
O
GS I
Transmit printer ID Hardware extension
O
GS P
Set horizontal and vertical
motion units
Software extension
O
GS c
Print counter Software extension
GS z 0
On-line/off-line recovery wait
time
Software extension
Function Type Command Name Matrix Category
Supported
Command
The TM-U950/U950P supports the commands marked with a O in the “Supported Command” column.
The TM-U950/U950P with the MICR option supports the commands marked with a
●
in the “Supported Command” column.