Specifications

Rev. A Command Descriptions 1-19
TM–U950/U950P Information Manual
The paper sensor(s) used to stop printing are selected by using n as follows:
ESC c 3 n
[Name] Select paper sensor(s) to output paper-end signals
[Format] ASCII ESC c 3 n
Hex 1B 63 33 n
Decimal279951n
[Range] 1 ≤
n
≤ 255
ESC c 3 n selects paper sensor(s) to output paper-end signals to a parallel interface. Multiple sensors
can be selected to output signals. Then if any of the sensors detects a paper-end, the paper-end signal
is output.
The default value is to enable the journal near-end, receipt near-end, journal-end, and receipt-end
sensors (n=15). This command is enabled only with a parallel interface and is ignored with a serial
interface.
Bit Off/On Hex Decimal Function
0
Off 00 0 Journal near-end sensor disabled.
On 01 1 Journal near-end sensor enabled.
1
Off 00 0 Receipt near-end sensor disabled.
On 02 2 Receipt near-end sensor enabled.
2
Off 00 0 Journal sensor disabled.
On 02 4 Journal sensor enabled.
3
Off 00 0 Receipt sensor disabled.
On 08 8 Receipt sensor enabled.
4
Off 00 0 Slip insertion sensor disabled.
On 10 16 Slip insertion sensor enabled.
5
Off 00 0 Slip ejection sensor disabled.
On 20 32 Slip ejection sensor enabled.
6, 7 — 00 0 Undefined.
Program Example
PRINT #1, CHR$(&H1B);"c4";CHR$(63);
←
All sensors enabled