Specifications

Confidential
SHEET
119
NO.
SHEET
REVISION
H
TITLE
NEXT
120
TM-U590 series
Specification
(STANDARD)
GS $ n
L
n
H
[Name] Set absolute vertical print position in page mode
[Format] ASCII GS $ n
L nH
Hex 1D 24 n
L
n
H
Decimal 29 36 n
L
n
H
[Range] 0 ≤ n
L
≤ 255, 0 ≤ n
H
≤ 255
[Description] • Sets the absolute vertical print starting position for buffer character data in page
mode.
• This command sets the absolute print position to [(n
L
+ n
H
× 256) × (vertical or
horizontal motion unit)] inches.
[Notes] • This command is effective only in page mode.
• If the [(n
L
+ n
H
× 256) × (vertical or horizontal motion unit)] exceeds the specified
printing area, this command is ignored.
• The horizontal starting buffer position does not move.
• The horizontal and vertical motion units are specified by GS P.
• The GS P command can change the horizontal and vertical motion unit.
However, the value cannot be less than the minimum horizontal motion amount,
and it must be in even units of the minimum horizontal motion amount.
• The reference starting position is that specified by ESC T.
• This command operates as follows, depending on the starting position of the
printing area specified by ESC T:
① When the starting position is set to the upper left or lower right, this command
sets the absolute position in the vertical direction.
② When the starting position is set to the upper right or lower left, this command
sets the absolute position in the horizontal direction.
[Reference] ESC $, ESC T, ESC W, ESC \, GS P, GS \, 3.12 Page Mode