Specifications

Confidential
SHEET
91
NO.
SHEET
REVISION
H
TITLE
NEXT
92
TM-U590 series
Specification
(STANDARD)
ESC 2
[Name] Select default line spacing
[Format] ASCII ESC 2
Hex 1B 32
Decimal 27 50
[Description] Selects approximately 4.23 mm {1/6"} line spacing.
[Notes] • The line spacing can be set independently in standard mode and in page mode.
[Reference] ESC 3
ESC 3 n
[Name] Set line spacing
[Format] ASCII ESC 3 n
Hex 1B 33 n
Decimal 27 51 n
[Range] 0 ≤ n ≤ 255
[Description] Sets the line spacing to [n × vertical or horizontal motion unit] inches.
[Notes] • The horizontal and vertical motion unit are specified by GS P. Changing the
horizontal or vertical motion unit does not affect the current line spacing.
• The GS P command can change the horizontal (and vertical) motion unit.
However, the value cannot be less than the minimum vertical movement
amount, and it must be in even units of the minimum vertical movement amount.
• In standard mode, the vertical motion unit (y) is used.
• In page mode, this command functions as follows, depending on the starting
position of the printable area:
① When the starting position is set to the upper left or lower right of the printable
area using ESC T, the vertical motion unit (y) is used.
② When the starting position is set to the upper right or lower left of the print able
area using ESC T, the horizontal motion unit (x) is used.
• The maximum line spacing is 1016 mm {40"}. When the setting value exceeds
the maximum, it is converted to the maximum automatically.
[Default] Line spacing corresponding to approximately 4.23 mm {1/6"}
[Reference] ESC 2, GS P