Specifications

3-4 Command Reference Rev. A
Status commands DLE EOT Real-time status transmission Hardware extension
O
DLE EOT BS Real-time MICR status
transmission
Hardware extension
ESC u Transmit peripheral device status Hardware extension
O
ESC v Transmit paper sensor status Hardware extension
O
GS ENQ Transmit real-time printer status Hardware extension
GS a Enable/disable Automatic
Status Back (ASB)
Hardware extension
O
GS r Transmit status Hardware extension
O
Mechanism control
commands
ESC < Return home Mechanical extension O
ESC F Set/cancel cut sheet reverse
eject
Mechanical extension
ESC U Turn unidirectional printing mode
on/off
Mechanical extension
O
ESC i Partial cut (one point left uncut) Mechanical extension
ESC m Partial cut (three points left
uncut)
Mechanical extension
ESC o Stamp Mechanical extension
ESC q Paper release Mechanical extension
O
GS V Select cut mode and cut paper Mechanical extension
Bar code commands GS H Select printing position of HRI
characters
Software extension
GS f Select font for HRI characters Software extension
GS h Set bar code height Software extension
GS k Print bar code Software extension
GS w Set bar code width Software extension
Macro function
commands
GS : Start/end macro definition Software extension
GS ^ Execute macro Software extension
Kanji control
commands
FS ! Select print mode(s) for Kanji
characters
Software extension
FS & Select Kanji character mode Software extension
FS – Turn underline mode on/off for
Kanji characters
Software extension
FS . Cancel Kanji character mode Software extension
FS 2 Define user-defined Kanji
characters
Software extension
FS C Select Kanji character code
system
Software extension
FS S Set Kanji character spacing Software extension
FS W Turn quadruple-size mode on/
off for Kanji characters
Software extension
Function Type Command Name Matrix Category
Supported
Command
The TM-U375/U375P supports the commands marked with a O in the “ Supported Command” column.
The TM-U375P supports the commands marked with a
● in the “ Supported Command” column.