Specifications

Rev. A Command Descriptions 1-35
TM–U375/U375P Information Manual
Fourth byte (paper sensor information)
GS r n
[Name] Transmit status
[Format] ASCII GS r n
Hex 1D 72 n
Decimal 29 114 n
[Range] 1 ≤ n ≤ 3
49 ≤ n ≤ 51
GS r n transmits 1 byte of status data specified by n as follows: paper sensor status when n=1 or 49, drawer
kick-out connector status when n=2 or 50, and cut-sheet (slip or validation paper) status when n=3 or 51.
Paper sensor status (n=1, 49)
Bit Off/On Hex Decimal Status for ASB
0
Off 00 0 Slip paper selected.
On 01 1 Slip paper not selected.
1
Off 00 0 Slip paper status: possible to print.
On 02 2 Slip paper status: not possible to print.
2
Off 00 0 Validation paper selected.
On 04 4 Validation paper not selected.
3
Off 00 0 Validation paper status: possible to print.
On 08 8 Validation paper status: not possible to print.
4 Off 00 0 Not used. Fixed to Off.
5, 6
Off 00 0 Cut-sheet sensor: slip or validation paper present.
On 60 96 Cut-sheet sensor: slip or validation paper not present.
7 Off 00 0 Not used. Fixed to Off.
Program Example
PRINT #1, CHR$(&H1D);"r";CHR$(1); ←
Transmit s pap er se nsor status
Bit Off/On Hex Decimal Status
0, 1
Off 00 0 Paper roll near-end sensor: paper adequate.
On 03 3 Paper roll near-end sensor: paper near end.
2, 3 — — — Undefined.
4 Off 00 0 Not used. Fixed to Off.
5, 6
Off 00 0 Cut-sheet sensor: slip or validation paper present.
On 60 96 Cut-sheet sensor: slip or validation paper not present.
7 Off 00 0 Not used. Fixed to Off.