Specifications

1-20 Command Descriptions Rev. A
ESC c 3 n
[Name] Select paper sensor(s) to output paper-end signals
[Format] ASCII ESC c 3 n
Hex 1B 63 33 n
Decimal 27 99 51 n
[Range] 0 ≤ n ≤ 255
ESC c 3 n selects paper sensor(s) to output paper-end signals to a parallel interface. The default value
is to enable the paper roll near-end sensor (n=3).
If either bit 0 or bit 1 is 1, the paper roll near-end sensor is selected as a paper-end sensor that is
enabled to output a paper-end signal.
If any of bits 4-7 are 1, the cut-sheet (slip or validation paper) sensor is selected as a paper-end sensor
that is enabled to output a paper-end signal.
When both of these sensors are selected to output signals and either one detects a paper-end, the
paper-end signal is output. This command is enabled only with a parallel interface and is ignored
with a serial interface.
The paper sensor(s) used to output paper-end signals are selected by using n as follows:
6 - - - Undefined.
7
Off 00 0 Validation ejection sensor disabled.
On 80 128 Validation ejection sensor enabled.
Program Example
PRINT #1, CHR$(&H1B);"c4";CHR$(1); ←
Paper roll near-end sensor enabled
Bit Off/On Hex Decimal Function
0
Off 00 0 Paper roll near-end sensor disabled.
On 01 1 Paper roll near-end sensor enabled.
1
Off 00 0 Paper roll near-end sensor disabled.
On 02 2 Paper roll near-end sensor enabled.
2-3 - - - Undefined.
4
Off 00 0 Cut-sheet (slip or validation) sensor disabled.
On 10 16 Cut-sheet (slip or validation) sensor enabled.
5
Off 00 0 Cut-sheet (slip or validation) sensor disabled.
On 20 32 Cut-sheet (slip or validation) sensor enabled.
Bit Off/On Hex Decimal Function