Specifications

Control Codes POSjet
®
1500 Programmer's Guide
Page 52 Rev N Nov-10
Ink Low When
At:
Signal ink low when x% of the ink has been
used.
This sets the point when the
printer reports ink low. The
printer does not stop printing
at ink low
Ink Low is OFF (never signal ink low)
Ink Low when at 75%
Ink Low when at 80%
Ink Low when at 85%
Ink Low when at 90%
Ink Low when at 95%
•
Ink Low when at 100%
Print Zone
Normal 2.5‖
•
This is accomplished by
shrinking the character
spacing.
Simulated 2.8‖
Vertical Control
Line Spacing
The line spacing can be defaulted to
6 or 8 lines per inch (lpi).
This is not available in and
TM-U325 mode
6 lpi
This is the default for most
Epson printers
8 lpi
•
Auto
Line Feed/
Carriage
Return
An auto line feed feature can be set as a default
where all [CR]‘s have a [LF] added. In
addition, a CR is added to a LF, and the CR
or LF can be configured to be ignored.
Setting Depends
on emulation.
Normal CR/LF actions. Both are processed.
Ignore all LF characters
Ignore all CR characters
Default for most Epson
printers.
Add a LF to all CR characters
Add a CR to all LF characters
•
Add a CR to all LF characters,
and add a LF to all CR characters
Page Length
The default page length can be set to various
lengths from 2 to 60 lines. Page length
configuration affects how the [FF] command
operates.
Page length can be set in
PcOS, M50, And Microline
only.
2 to 60 lines
40
Fonts
Font
The default print mode can be set to 12 x 12
draft, 12 x 14 large draft, or 24 x 32 NLQ
modes.
This is not configurable in all
emulations.
12 x 12 draft
•
12 x 14 large draft
24 x 32 NLQ
Pitch (CPI)
The default print pitch can be set to 8, 10, 12,
15, 17.1, 20, or 24 characters per inch.
PcOS Only
8 cpi
10 cpi
12 cpi
15 cpi
17.1 cpi
PcOS
20 cpi
24 cpi