Specifications

Programmer's Guide POSjet
®
1500 Codes and Commands
Nov-10 Rev N Page 41
Inserting Validation Forms
The POSjet
®
1500 is designed to run validation either by using application software, or manually. Forms can be
inserted in either landscape or portrait orientation. Regardless of the orientation, the insertion process is the same.
The POSjet
®
1500 can accept forms with measurements between 2.75" x 2.75" (69.8mm x 69.8mm) and 8.5" x 11"
(215.9mm x 279.4mm).
1. Send appropriate control commands from your system to initiate the validation process or press the FORM
Button to enter validation mode.
2. When the FORM INDICATOR LIGHT starts blinking, insert the validation paper into the validation paper inlet using
the right edge (form stop) of the validation paper inlet as a guide.
3. When the validation sheet is detected by the sensors, the FORM INDICATOR LIGHT changes from blinking to
steady ON. The paper is automatically drawn into the printer, and printing begins.
4. When the FORM INDICATOR LIGHT begins to blink again after printing, remove the validation paper.
Printable Side of Form
The side of the inserted form that is facing the front end of the printer is where the printing will always occur.
Always insert forms so that the side of the form that you want the printing to occur on is facing forward.