Specifications

Appendix A POSjet
®
1500 Programmer's Guide
Page 268 Rev N Nov-10
Appendix A: Common Operational Questions
Task
Approach
Change Paper Rolls
Open the printer‟s front paper cover. Insert the new paper roll
so that it unwinds from the bottom and rests on the top of the
front cover and aligns with the paper stop on the front cover.
Latch both sides of the paper cover. The paper will load
automatically.
See “Installing a New Paper Roll Using Insta-Load
®
”, on page
33.
Feed Paper
Press and release the FEED Button for a single line.
Press and hold the FEED Button for continuous feed.
Change Ink Cartridges
DO NOT USE ANYTHING OTHER THAN NEW
CARTRIDGES WHEN REPLACING EMPTY
CARTRIDGES
Open the printer‟s front cover. Take the ink cartridge(s) out of
the carriage system and replace with new cartridge(s). Press
and release the NEW CARTRIDGE Button.
See “Installing Ink Cartridges”, on page 31.
Clean Ink Cartridges
Press and release the NEW CARTRIDGE Button 2-3 times. If
the cartridge still is not working correctly, replace the
cartridge(s).
Print Ink Level Status
Press and release the NEW CARTRIDGE Button.
Cycle Through Configuration Menu
Follow the directions that print on the configuration summary
receipt after entering Configuration Mode.
Save Configuration Settings
Press and release the * Button at any time.
Exit Self-Test Mode
Press and release the * Button at any time.
Exit Configuration Mode
Press and release the * Button at any time.
Turning Printer ON
Press and release the * Button.
Turning Printer OFF
Press and release the * Button.
Removing Ink Low Warning After Installing New Ink Cartridges
Press and release the NEW CARTRIDGE Button immediately
after installing the new ink cartridge(s).
Placing Printer Into Self-Test Mode
1. Press and release the * Button to place the printer into
STANDBY/OFF mode. (The POWER INDICATOR LIGHT will
be off.)
2. Press and hold the NEW CARTRIDGE Button.
3. While holding the NEW CARTRIDGE Button, press and
release the * Button.
4. When the red, ERROR INDICATOR LIGHT blinks, release
the NEW CARTRIDGE Button.
5. Follow the directions printed on the receipt to select the
desired TEST option.
Entering Configuration Mode
1. Unplug the power cord from the printer.
2. Press and hold the FEED Button and plug the power
cord back into the printer.
3. Continue to hold the FEED Button until the ERROR
INDICATOR LIGHT begins to blink.
4. Release the FEED Button. A receipt will print. This
Configuration Summary Receipt shows how your printer
is configured. Follow the directions at the bottom of the
receipt to change and save settings.
5. See “ Configuration Mode” on page 47.
Table 69 Common Operator‟s Questions (FAQ‟s)