Specifications

EPOS Control Codes POSjet
®
1500 Programmer's Guide
Page 230 Rev N Nov-10
Mechanism Control Commands
Function Select cut mode and cut paper
ASCII [GS] V <m> <n>
Hexadecimal 1DH 56H <m> <n>
Decimal <29> <86> <m> <n>
Description When <m> = 1 or 49, <n> is not used and a partial cut is performed. When <m> = 66, [GS] V
<m> <n> executes a partial cut (one point left uncut) after paper is fed [cutting position (<n> x
approximately 1/144 inch)]. When using the command, there is a gap between the auto-cutter
position and the print position. The [GS] V <m> <n> command is only effective when input at the
beginning of a line. The [GS] V <m> <n> command executes paper feeding to the manual cutting
position.
Function Partial knife cut EPOS ONLY
ASCII [ESC] i
Hexadecimal 1BH 69H
Decimal <27> <105>
Description The [ESC] i command performs a partial knife cut.
Function Perform a partial knife cut EPOS ONLY
ASCII [ESC] m
Hexadecimal 1BH 6DH
Decimal <27> <109>
Description The [ESC] m command performs a partial knife cut.
Function Sound buzzer EPOS ONLY
ASCII [BEL]
Hexadecimal 07H
Decimal <07>
Description The [BEL] command sounds the internal buzzer, if equipped.
Function Sound buzzer EPOS ONLY
ASCII [ESC] BEL
Hexadecimal 1BH 07H
Decimal <27> <07>
Description The [ESC] BEL command sounds the internal buzzer, if equipped.
Function Load Check for Processing EPOS ONLY
ASCII [FS] a 1
Hexadecimal 1CH 61H 31H
Decimal <28> <97> <49>
Description Position a form to the top edge. This command is typically used to print the face of a check in
rotated print mode. It will feed the check into the printer so the top of the check is in position to
print. See ―Validation Form Requirements‖ on page 16.