Specifications

EPOS Control Codes POSjet
®
1500 Programmer's Guide
Page 224 Rev N Nov-10
Function Select Paper Type for Command Settings
ASCII [ESC] c 1 <n>
Hexadecimal 1BH 63H 31H <n>
Decimal <27> <99> <49> <n>
Range n = 1, 1 n 3, 8 n 11
Description ESC c 1 n selects paper type(s) for setting. Paper roll and validation paper are available. Both bits
0 and 1 indicate paper roll and if either of them is available, the paper roll is selected as the print
sheet. The commands that need to select paper types for setting are ESC 2, ESC 3, GS L, and GS
W. The value of n is used as follows:
Bit
Off/On
Hex
Decimal
Function
0
Off
00
0
Not Used.
On
01
1
Not Used.
1
Off
00
0
Paper roll disabled.
On
02
2
Paper roll enabled.
2
—
—
—
Undefined.
3
Off
00
0
Validation paper disabled.
On
08
8
Validation paper enabled.
4–7
—
—
—
Undefined.
Function Select Paper Type for Command Settings
ASCII [ESC] f <t
1
><t
2
>
Hexadecimal 1BH 66H <t
1
><t
2
>
Decimal <27> <116> <t
1
><t
2
>
Range 0 t
1
15
0 t
2
64
Description ESC f t1 t2 sets the time that the printer waits for validation paper to be inserted to t
1
1 minutes,
and the time from detection of the validation to the start of printing to t
2
0.1 seconds. When
t1=0, the validation waiting time is not set and the printer continues waiting for a validation to be
inserted. The default validation waiting time is not set, and the start operation time is set to 10
seconds (t
1
=0, t
2
=10). This setting alone, however, does not cause the printer to immediately start
waiting for a validation to be inserted. The setting becomes effective when validation paper is
used. DLE ENQ is used to cancel the validation waiting state.