Specifications

Programmer's Guide POSjet
®
1500 EPOS Control Codes
Nov-10 Rev N Page 205
Line Spacing Commands
Function Select Default Line Spacing
ASCII [ESC] 2
Hexadecimal 1BH 32H
Decimal <27> <50>
Description The [ESC] 2 command sets the line spacing to 1/6 inch, which is equivalent to 12 dots.
Function Set Line Spacing
ASCII [ESC] 3 <n>
Hexadecimal 1BH 33H <n>
Decimal <27> <51> <n>
Range 0 n 255
Description The [ESC] 3 <n> command sets the line spacing to [<n> x (1/144)] inches. The default setting of
the paper feed amount is 1/6 inch (<n> = 24). The line spacing can be set in half-dot units.
Character Commands
Function Set Right-Side Character Spacing
ASCII [ESC] SP <n>
Hexadecimal 1BH 20H <n>
Decimal <27> <32> <n>
Range 0 n 255
Description The [ESC] SP <n> sets the right-side character spacing in [<n> x (1/160)] inches. It is used to
change the spacing between characters. The default right-side character spacing is set to zero.
(<n> = 0). Right-side character spacing can be set in half-dot units.
Function Select/Cancel User-Defined Character Set
ASCII [ESC] % <n>
Hexadecimal 1BH 25H <n>
Decimal <27> <37> <n>
Range 0 n 255
Description The [ESC] % <n> command selects or cancels the user-defined character set. When the least
significant bit (LSB) of <n> is one, the user-defined character set is selected. When <n> is zero,
the internal character set is selected, which is the default setting.
Note 1 In TM-U325D mode, the command only functions if the buffer is set to 40 characters.