Setup guide

Safety Instructions

❏ Unplug the scanner and refer servicing to qualified service

personnel under the following conditions:

If the power cord or plug is damaged; if liquid has entered the

scanner; if the scanner has been dropped or the case damaged;

if the scanner does not operate normally or exhibits a distinct

change in performance. (Do not adjust controls that are not

covered by the operating instructions.)

❏ If you plan to use the scanner in Germany, observe the

following:

To provide adequate short-circuit protection and

over-current protection for this scanner, the building

installation must be protected by a 10 or 16 Amp circuit

breaker.

Note for German-speaking users:

Bei Anschluss des Scanner an die Stromversorgung muss

sichergestellt werden, dass die Gebäudeinstallation mit einer 10 A-

order 16 A-Sicherung abgesichert ist.

Warnings, Cautions, and Notes

Warnings

must be followed carefully to avoid bodily injury.

Cautions

must be observed to avoid damage to your equipment.

Notes contain important information and useful tips on the operation

of your scanner.