TM-U295/TM-U295P User’s Manual / Bedienungsanleitung Gebruikershandleiding / Manuel d’utilisation Manual do utilizador / Manual del usuario Manuale dell’utente/ 使用说明书 / 使用說明書 404898801
Printer Parts 4 printer cover 5 control panel 3 upper case 2 POWER switch 1 document table DIP Switch Tables Serial interface Serial transmission speed SW Function ON OFF 8 7 Transmission speed 1 Data receive error Ignored Prints “?” ON ON 1200 bps 2 Receive buffer 35 bytes 512 bytes ON OFF 2400 bps 3 Handshaking XON/XOFF DTR/DSR OFF ON 4 Data word length 7 bits 8 bits OFF OFF 9600 bps 5 Parity check Yes No 6 Parity selection Even Odd 7, 8 Transmission speed (S
English All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Seiko Epson Corporation. No patent liability is assumed with respect to the use of the information contained herein.
English WARNING: Shut down your equipment immediately if it produces smoke, a strange odor, or unusual noise. Continued use may lead to fire. Immediately unplug the equipment and contact your dealer or a SEIKO EPSON service center for advice. Never attempt to repair this product yourself. Improper repair work can be dangerous. Never disassemble or modify this product. Tampering with this product may result in injury or fire. Be sure to use the specified power source.
English Unpacking The following items are included with the standard specification printer. If any item is damaged, contact your dealer. ❏ Printer ❏ Damper ❏ Ribbon cassette Control Panel RELEASE button Press this button to insert or remove paper. REVERSE button Feeds paper backward. FORWARD button Feeds paper forward. POWER LED ON when the printer is on. RELEASE LED ON when the printer is in release mode (to insert or remove paper). OFF when the printer is in clamp mode (to hold paper).
English Installing a Ribbon Use the EPSON ERC-27 ribbon cassette. The use of any ribbon cassettes other than those approved by EPSON may damage the printer and will void the warranty. 1. Turn the printer on using the power switch on the left side. 2. Press the RELEASE button (the RELEASE LED lights). This puts the printer in the paper release mode. 3. Turn the printer off. CAUTION: Perform the steps above to make sure the printer is in the paper release mode before you install or remove a ribbon cassette.
English 9. To put the cover back on the printer, first align the left side of the cover; then insert the tab on the top; then press the bottom until it clicks into place (see illustration 2). Inserting Paper Note: Do not use wrinkled or curled paper. Be sure to use roll paper that meets the specifications. 1. Make sure a ribbon cassette is installed in the printer. 2. Turn on the printer. The POWER light comes on. 3. Press the RELEASE button.
English TM-U295/TM-U295P Specifications Printing method Impact dot matrix, 7-pin shuttle type Printing direction Unidirectional Characters per line (default) 5 × 7 font: 35; 7 × 7 font: 42 Character matrix 5 × 7 with 1-dot spacing (normal dots) 7 × 7 with 3-dot spacing (half dots) Character size 5 × 7 font: 1.6 × 2.9 mm {0.063 × 0.114"} 7 × 7 font: 1.3 × 2.9 mm {0.051 × 0.
