Operator`s manual

Commands 5-23
[Description] Sets the time that the printer waits for slip paper to be inserted and
the time from insertion of the sheet to the start of printing.
•
t1
specifies the wait time for a cut sheet to be inserted. There is no
limitation for the wait time and the printer waits until slip paper is
inserted.
•
t2
specifies the time from insertion of the sheet to the start of
printing.
• The printer starts operation [
t2
× 0.1] seconds after detecting slip
paper.
[Note] When either
t1
or
t2
is out of the specified range, this command does
not change the previously set wait time.
[Default]
t1
= 0,
t2
= 10
ESC p
m t1 t2
[Name] Generate pulse
[Format] ASCII ESC p
m t1 t2
Hex 1B 70
m t1 t2
Decimal 27 112
m t1 t2
[Range]
m
= 0, 1, 48, 49
0 ≤
t1
≤ 255
0 ≤
t2
≤ 255
[Description] Outputs the pulse specified by
t1
and
t2
to connector pin
m
as
follows:
[Notes] • The pulse ON time is [
t
1
✕ 2 ms] and the OFF time is [
t2
✕ 2 ms].
•If
m
is outside the specified range, the printer ignores this
command and the following data is processed as normal data.
ESC q
[Name] Paper release
[Format] ASCII ESC q
Hex 1B 71
Decimal 27 113
[Description] Releases the paper
[Notes] • This command is available only in standard mode.
• When the panel button is disabled and the specified paper sensor
detects a paper-end, the printer releases the paper, regardless of
this command.
m Connector pin
0, 48 Drawer kick-out connector pin 2
1, 49 Drawer kick-out connector pin 5