Operator`s manual

Commands 5-19
dx
= [
dxL
+
dxH
✕ 256]
dy
= [
dyL
+
dyH
✕ 256]
The printable area is set as shown in the figure below.
[Notes] • The maximum printable area in the horizontal direction (
x
direction) is 210 dots.
• The maximum printable area in the vertical direction (
y
direction)
is 480 dots.
• If the setting values exceed the printing area, it set to the
maximum printing area automatically, depending on the values
from
xL
to
dyH
.
• If (horizontal print starting position + horizontal length) or
(vertical print starting position + vertical length) is outside the
printable area, the maximum printing area is set to the printable
area.
• When the print data is buffered in the specified printing area, the
length of the printing area in both the horizontal and vertical
direction should be 8 dots or more.
• The printing area should accommodate to the size of the print
sheet.
• When the starting point (
x
0,
y
0) exceeds the printing area, this
command is ignored.
• In standard mode, only setting of this command is effective.
[Default]
xL
=
xH
=
yL
=
yH
= 0
dxL
= 210,
dxH
= 0,
dyL
= 224,
dyH
= 1
[Reference] CAN, ESC L, ESC T
ESC c 3
n
[Name] Select paper sensor(s) to output paper end signals
[Format] ASCII ESC c 3
n
(0, 0)
Printable area of the paper
(x0, y0) dx
dy Printing area
(x0+dx-1,
y0+dy-1)
(209 dots, 479
dots)