Operator`s manual

Commands 5-15
[Notes] • Up to 32 tab positions (
k
= 32) can be set. Data exceeding 32 tab
positions is processed as normal data.
•When [
n
]
k
is less than or equal to the preceding value [
n
]
k
-1, tab
setting is finished and the following data is processed as normal
data.
•When [
n
]
k
exceeds the number of characters printable on one line,
the tab position set is equal to the maximum printable column
plus 1.
• The previously specified horizontal tab positions do not change,
even if the character width changes.
• The right-side spacing is set independently in standard and page
modes. The horizontal tab setting is set by using amount of the
right-side spacing of the mode used.
[Default] The default tab positions are at intervals of 8 characters (columns 9,
17, 25,...) for the default character font.
ESC F
n
[Name] Set/cancel cut sheet reverse eject
[Format] ASCII ESC F
n
Hex 1B 46
n
Decimal 27 70
n
[Range] 0 ≤
n
≤ 255
[Description] Sets or cancels the cut sheet reverse eject specified by FF.
• When the LSB of
n
is 0, reverse eject is canceled and forwqrd eject
is set.
• When the LSB of
n
is 1, reverse eject is set.
[Note] When n cancels reverse eject, this command sets forward ejection
automatically.
[Default]
n
= 0
[Reference]
FF
ESC J
n
[Name] Print and feed paper
[Format] ASCII ESC J
n
Hex 1B 4A
n
Decimal 27 74
n
[Range] 0 ≤
n
≤ 255
[Description] Prints the data in the print buffer and feeds the paper by
n
/60
inches.
[Note] Sets the print position to the beginning of the line.
ESC K
n
[Name] print and revers feed