Service manual

Rev. B Handling and Maintenance 3-15
TM-U200 Series (Type B) Service Manual
Confidential
Lubrication Points
The following table describes the lubrication points, type, and class. The numbers in the
following table correspond to the numbers in the lubrication and adhesive points diagrams in
the Appendix on pages A-7 and A-8.
Tool List
The required tools for this printer are as follows:
❏
Brush #1
❏
Cleaning brush
❏
Phillips screwdriver No. 1
❏
Phillips screwdriver No. 2
❏
Phillips screwdriver No. 2 (with long handle)
❏
Flatblade screwdriver
❏
Pliers
❏
Retaining pliers #2.3
❏
Thickness gauge (0.50 mm, 0.55 mm, 0.60 mm)
❏
Tweezers
❏
Slanted blade cutter
Lubrication points
No. Lubrication point Lubricant type
(1) Contact points between the carriage shaft and
carriage sub assembly (2 points)
O-10
(2) Ribbon intermediate gear shaft G-31
(3) Both ends of the guide roller G-31
(4) Both ends of the receive roller G-31
(5) Switching points of ribbon switch lever G-31
(6) Switching point of ribbon release lever G-31
(7) Left and right ribbon frame assembly mounting
shaft in the base frame assembly
G-31
(8) Middle of the paper hold roller shaft G-31