Service manual

1-12 Features and General Specifications Rev. B
Confidential
Drawer kick-out drive signal
CAUTION:
To avoid overcurrent, resistance of the drawer kick-out solenoid must be 24 Ω or more.
NOTES:
❏
Two driver transistors cannot be energized simultaneously.
❏
The drawer drive duty must be as shown below:
❏
Be sure to use the printer power supply (connector pin 4) for the drawer power source.
CAUTION:
Do not connect a telephone line to the drawer kick-out connector; otherwise the printer
and the telephone line may be damaged.
Output signal: Voltage = Approximately 24 VDC
Current = 1 A or less
Output waveform: Outputs the waveforms in Figure 1-8 to pins
2 and 5 of the connector.
t
1 (ON time) and
t
2
(OFF time) are specified by
ESC p
.
Figure 1-9 Drawer kick-out drive signal output waveform
t
1 x 2 ms
t
2 x 2 ms
ON time
(ON time + OFF time)
≤
0.2