Service manual
Table Of Contents
- Revision Table
- Introduction
- Chapter 1
- Features and General Specifications
- Chapter 2
- Mechanism Configuration and Operating Principles
- Printer Mechanism Operating Principles
- Print mechanism unit
- Print head unit movement
- Wire movement when a single dot is printed
- Printing a character (9x9 font)
- Paper Feed Mechanism Unit
- Paper loading (semi-automatic loading)
- Paper feeding
- Ribbon Feed Mechanism Unit
- Ribbon feeding
- Detection Mechanism Unit
- Home position detection mechanism
- Paper detection mechanism
- Paper roll near-end detection mechanism (optional)
- Auto-cutter mechanism
- Ribbon Switch Mechanism Unit
- Electrical Circuitry Operating Principles
- Principles of Operation
- Printer Mechanism Driver Circuits
- Printer Mechanism Operating Principles
- Chapter 3
- Handling and Maintenance
- Chapter 4
- Troubleshooting
- Chapter 5
- Disassembly, Assembly, and Adjustment
- Small Part Specifications
- Disassembly
- Sub-assembly A
- Main Assembly 1
- Main Assembly 2
- Main Assembly 3
- Main Assembly 4
- Main Assembly 5
- Main Assembly 6
- Main Assembly 7
- Main Assembly 8
- Main Assembly 9
- Main Assembly 10
- Main Assembly 11
- Main Assembly 12
- Main Assembly 13
- Main assembly 14
- Main Assembly 15
- Main Assembly 16
- Main Assembly 17
- Main Assembly 1 (Case Unit)
- Main Assembly 2 (Case Unit)
- Main Assembly 3 (Case Unit)
- Main Assembly 4 (Case Unit)
- Main Assembly 5 (Case Unit)
- Main Assembly 6 (Case Unit)
- Main Assembly 7 (Case Unit)
- Main Assembly 8 (Case Unit)
- Main Assembly 9 (Case Unit)
- Main Assembly 10 (Case Unit)
- Main Assembly 11 (Case Unit)
- Main Assembly 12 (Case Unit)
- Adjustment
- Appendix
- Appendix
- Addendum 1
- Main Circuit Board Types and Maintenance
- Addendum 2
- Lower Plate Change and ROM Spacer Abolition
- Addendum 3
- Auto-Cutter Release Tab Change
Rev. B Disassembly, Assembly, and Adjustment 5-49
TM-U200 Series (Type B) Service Manual
Confidential
4. Attach the spacers (if desired) and near-end detector assembly to the lower case and secure
them with the screws. Make sure the spacers are positioned in the correct direction, as
shown in the illustration.
5. Insert the near-end detector’s lead wires into the connector.
✔
Make sure to arrange the lead wires as shown in the illustration.
6. The inner diameter of the paper core should be 10.5 to 12.5 mm (0.41 to 0.49”).
Round corner
Round corner
Near-end detector assembly
CPT-B (M3x12)
of spacer
[0.59 to 0.78 N • m
(6 to 8 kgf • cm)]
Connector CN11
Near-end detector’s
lead wires