Service manual

Rev. B Disassembly, Assembly, and Adjustment 5-37
TM-U200 Series (Type B) Service Manual
Confidential
Main Assembly 7 (Case Unit)
Auto-cutter assembly
1. To attach the auto-cutter assembly to the auto-cutter plate assembly, fit the auto-cutter
assembly onto the left dowel of the auto-cutter plate assembly first, and then fit the right
side onto the right to match the right dowel.
The procedure in step 2 below differs depends on if you attach the release lever to the auto-
cutter lock lever or not. See Addendum 3 for information about the release lever.
2.
When you attach the release lever:
Insert the tab on the auto-cutter lock lever into the slit of
the release lever, then attach them into the shaft of the auto-cutter plate assembly. Attach the
auto-cutter lock lever spring with the RE (2.3).
Auto-cutter assembly
Auto-cutter plate assembly
(0.59 to 0.78 N • m (6 to 8 kgf • cm)]
CBS-tite (M3x4)
Dowel
Dowel
RE (2.3)
Auto-cutter lock lever
Auto-cutter lock
lever spring
Release lever
Slit
Tab
Auto-cutter plate
assembly