User`s manual

TM-T88V-DT User’s Manual 17

English

4. Close the cutter cover.

5. Open the roll paper cover and remove the jammed paper.

Controlling the Speaker Volume

You can control the speaker volume with the speaker volume control on the

operating system on the computer.

Changing the Orientation of the Optional Customer Display

Hold the main body with your hand and move the optional customer display to

change the direction or angle. Make sure to move it in their mobile range only.

CAUTION:

Do not rotate the customer display with excessive force. Doing so may break

the customer display.

The mobile range of the display is as follows. See the illustration below.

a. Display tilt: Maximum angle of 48

(4 levels, 5 positions)

b. Display rotation: Maximum angle of 300

c. Arm rotation: Maximum angle of 270

(L-shaped pole only)

Securing the Product

You can secure the product to the installation surface with optional affixing tape

(hook and loop fastener, four pairs, Model: DF-10), following the steps below.

1. Prepare four pairs of affixing tape.

2. Turn over the product so that you can see its bottom.

3. With two pieces of the affixing tape combined, peel off the backing paper of a

pair on one side, and paste it to one of the specified positions on the bottom of

the product. Illustration below shows the positioning lines for pasting the

pieces of the affixing tape.

4. In the same way, paste other three pairs of tape in the specified positions.

48°

270°

300°