Specifications

CONFIDENTIAL
Paper roll Two-dimension code commands GS ( k
Ver. 10.05 p. 578
[Description: Applied to RSS-14 Stacked and RSS-14 Stacked Omnidirectional]
■ The data shown below is added automatically in encoding.
• Application identifier (AI): The AI is "01".
• Check digit (1 character)
• Guard pattern and separator pattern
[Note for RSS Expanded Stacked]
■ The data shown below is added automatically in encoding.
• Guard pattern, finder pattern and separator pattern
■ For encoding, the width of the symbol is decided by the setting value of <Function 371> of this command
(nL + nH x 256) and the current printing area (the area from the current printing position to the edge of
the printing area).
• When (nL + nH = 256) = 0, the width of the symbol is the current printing area.
• When (nL + nH 256) ≠ 0 is specified and the setting value is greater than the current printing area, the
width of the symbol is the current printing area.
• In cases other than above, (nL + nH x 256) is the width of the symbol.
[Model-dependent variations] TM-T90, TM-T88IV, TM-T70, TM-L90, TM-P60
TM-T90, TM-T88IV, TM-T70, TM-L90
This model does not support this Function.
TM-P60
TM-P60 with peeler supports this function.
In standard mode, symbols with height greater than 1,200 dots cannot be printed with this
printer. 2-dimensional RSS symbols are printed with the “printing control mode = fine” regardless
of the setting of Function 48 of GS ( K.