Specifications

CONFIDENTIAL
Paper roll Bar code commands GS k
Ver. 10.05 p. 352
■ The special characters ("(“,”)”) are processed as shown in the table below.
■ Adds the guard pattern and finder pattern automatically.
■ When HRI characters are designated to be added, special character HRI characters are processed as follows.
• The HRI character of function character (FNC1) is not printed.
• The HRI characters of special characters ("(", ")") are printed as the respective characters ("(", ")").
• The HRI characters of bar code data ["{" + ("(", ")")] are printed as the respective characters ("(", ")").
■ When the bar code height set with GS h is smaller than [34 times the module width], a bar code with a
height (excluding the HRI characters) of [module width x 34] is printed, without reference to the GS h
setting.)
[Model-dependent variations] TM-J2000/J2100, TM-T90, TM-L90, TM-T88IV, TM-T70, TM-P60
Special characters
Character Hex Decimal Processing
( 28 40 "(" is inserted for the HRI character. It can be used when you want the
HRI characters that indicate AI to look nice when used with the pair of
")." .
) 29 41 After d1, the first ")" is processed as AI and the data part delimiter,
and ")" is inserted for the HRI characters. ")" are inserted for the HRI
characters for subsequent ")" .
Program Example for all printers Print Sample
PRINT #1, CHR$(&H1D);"h";CHR$(80); ← Set height
PRINT #1, CHR$(&H1D);"k";CHR$(2); ← Print bar code
PRINT #1, "496595707379";CHR$(0);
PRINT #1, CHR$(&HA);
PRINT #1, CHR$(&H1D);"k";CHR$(67);CHR$(12);
PRINT #1, "496595707379"; ← Print bar code