Specifications

CONFIDENTIAL
Paper roll Status commands GS r
Ver. 10.05 p. 330
TM-T90, TM-T88IV, TM-L90
■ Paper sensor status (n = 1, 49)
• When the roll paper end sensor detects a paper-end, the printer goes offline and does not execute this
command. Therefore, bits 2 and 3 of the paper sensor status do not transmit a paper-end status.
TM-T70
■ Paper sensor status (n = 1, 49)
• When the roll paper end sensor detects a paper-end, the printer goes offline and does not execute this
command. Therefore, bits 2 and 3 of the paper sensor status do not transmit a paper-end status.
• When the cover is open, the status of the roll paper near end sensor (bit 0, 1) when the cover is open retain
the value when the cover was closed immediately before.
TM-P60
■ Paper sensor status (n = 1, 49)
• Bits 0 and 1 are not supported.
• When the roll paper end sensor detects a paper-end, the printer goes offline and does not execute this
command. Therefore, bits 2 and 3 of the paper sensor status do not transmit a paper-end status.
TM-U230
■ Paper sensor status (n = 1, 49)
• When the roll paper end sensor detects a paper-end, the printer goes offline and does not execute this
command. Therefore, bits 2 and 3 of the paper sensor status do not transmit a paper-end status.
TM-U220
■ Paper sensor status (n = 1, 49)
• The roll paper near-end sensor is an option. If the printer is not equipped with the paper near-end sensor,
bits 0 and 1 of the third byte are always ON, “Paper adequate.”
• When the roll paper end sensor detects a paper-end, the printer goes offline and does not execute this
command. Therefore, bits 2 and 3 of the paper sensor status do not transmit a paper-end status.