Specifications

CONFIDENTIAL
Paper roll Print position commands GS \
Ver. 10.05 p. 177
GS \
EXECUTING COMMAND
[Name] Set relative vertical print position in page mode
[Format] ASCII GS \ nL nH
Hex 1D 5C nL nH
Decimal 29 92 nL nH
[Range] –32768 ≤ (nL + nH × 256) ≤ 32767
[Default] None
[Printers not featuring this command] TM-U230, TM-U220
[Description] In page mode, moves the vertical print position to (nL + nH × 256) × (vertical or horizontal motion unit) from
the current position.
[Notes]
■ This command is enabled only in page mode. If this command is processed in standard mode, it is ignored.
■ The printer ignores any setting that exceeds the print area set by ESC W.
■ A positive number specifies movement downward, and a negative number specifies movement upward. N
pitch movement downward: (nL + nH × 256) = N. Use the complement of N for setting N pitch movement
upward: (nL + nH × 256) = 65536 – N.
■ The horizontal or vertical motion unit is used for the print direction set by ESC T.
• When the starting position is set to the upper left or lower right of the print area using ESC T, the
vertical motion unit is used.
• When the starting position is set to the upper right or lower left of the print area using ESC T, the
horizontal motion unit is used.
■ Even if vertical or horizontal motion unit is changed after changing the print position, the setting of print
position will not be changed.
■ “\” is corresponds to “\” in JIS code set.
[Model-dependent variations] TM-J2000/J2100, TM-T90, TM-T88IV, TM-T70, TM-L90, TM-P60