Specifications
No
EPSON
TITLE
EPSON Advanced Printer Driver for TM series
StatusAPI
Reference Manual
Revision
L
NEXT
43
SHEET
42
3.25.
BiMICRReadCheck
[Function]
Executes check reading.
If 0 is specified for the check insertion wait time, the printer’s wait time is canceled. Furthermore, the check insertion wait
time after MICR reading is finished is reset to 0, the printer’s default value.
[Format]
int BiMICRReadCheck( int nHandle, BYTE readFont, BYTE waitInsertionTime)
[Argument]
int nHandle
Specifies the handle value of the printer executing the function. The return value in BiOpenMonPrinter() is specified.
BYTE readFont
Specifies the reading font.
0:E13B
1:CMC 7
BYTE waitInsertionTime
Specifies the check insertion wait time.
0 ~ 15 (x 60 sec.) (The printer’s default is 0)
[Return Values]
If execution is successful, 0 is returned. If an error occurs, the following error codes (negative values) are returned.
ERR_ HANDLE The handle value which specifies the printer is incorrect.
ERR_WITHOUT_CB Cannot execute because either BiMICRSetReadBackFunction or
BiMICRSetReadBackWnd has not been called.
ERR_PARAM The argument has an error.
ERR_NOT_SUPPORT Not supported by this printer.
ERR_OFFLINE It was opened in the offline state, so it cannot be used until the online state is recovered.
ERR_NOT_EPSON The printer is not an EPSON printer, so it cannot be used.
[Caution]
•
Be sure to call either BiMICRSetReadBackFunction or BiMICRSetReadBackWnd before calling this function.
[Supported Printers]
TM-H6000, TM-H6000II, TM-U675, TM-H5000II, TM-J7000/7100