Specifications

2-36 Hardware
Confidential
2. Connector model: Printer side: MOLEX 52065-6615 or equivalent
User side: 6-position 6-contact (RJ12 telephone jack)
+24 V is output through pin 4 when the power is turned on. However, pin 4 must be used
only for the drawer.
Drawer kick-out connector
3. Drawer kick-out drive signal
Output signal: Output voltage: Approximately 24 V
Output current: 1A or less
CAUTION:
To avoid an overcurrent, the resistance of the drawer kick-out solenoid must be 24
ΩΩ
or
more.
Output waveform: Outputs the waveforms in the figure of Drawer Kick-out Drive Signal
Output Waveform to the points A and B in the figure of Drawer Circuitry.
t1
(ON time) and
t2
(OFF time) are specified by
ESC p
or
DLE DC4
.
Drawer kick-out connector pin assignments
Pin Number Signal name Direction
1Frame GND —
2 Drawer kick-out drive signal 1 Output
3 Drawer open/close signal Input
4+24 V —
5 Drawer kick-out drive signal 2 Output
6Signal GND —
16