Specifications

Hardware 2-35
TM-H6000/H6000P Developer’s Guide
Confidential
Parallel interface connector panel external appearance
Interface Connectors
See “Interfaces” earlier in this chapter.
Power Supply Connector
This connector is used to connect the printer to an external power source.
1. Pin assignments: See the table below.
2. Connector model: printer side: Hoshiden TCS7960-532010 or equivalent
Power supply connector
Drawer Kick-out Connector (Modular Connector)
The pulse specified by
ESC p
or
DLE DC4
is output to this connector. The host can confirm the
status of the input signal by using the
DLE EOT
,
GS r
, or
GS a
(ASB) commands.
1. Pin assignments: See the table on the next page.
Power supply connector pin assignments
Pin Number Signal Name
1 +24 VDC
2GND
3NC
Shell Frame GND
(Use is prohibited.)