Specifications

2-4 Hardware
Confidential
Slip paper glued area
• Since the slip BOF sensor uses a photo sensor, do not use paper that has holes at the
sensor position, or is translucent.
• Since the slip TOF sensor uses a reflective photo sensor and it detects from the back of
slip paper, do not use paper that has holes or dark portions with low reflection (less than
40% reflection) at the sensor position.
• Since the slip paper ejection sensor uses a reflective photo sensor and it detects from the
surface of the paper roll, do not use paper that has holes or dark portions with low
reflection (less than 40% reflection) at the sensor position.
• Use thinner paper (N30 or equivalent) between the top and bottom sheets of multi-ply
paper. If thick paper is used, the copy capability is lowered.
Prohibited area for paper holes and low reflection
Paper feed
direction
Glued area
Use carefullyUse carefullyDo not use
OK to use
15
30
20
10
Paper feed direction
Paper holes and
translucence prohibited in
this area.
Area where paper holes are
prohibited and reflection rate
for the surface on paper
should be 40% or more.
Area where paper holes are
prohibited and reflection rate
for the back on paper should
be 40% or more.
[Units: mm (All the numeric values are typical.)]