Specifications

General Information 1-15
TM-H6000/H6000P Developer’s Guide
Confidential
❏
Slip eject sensor:
• The slip eject sensor is located in the slip paper exit and detects whether the paper is
removed or not after printing. The printer does not proceed to the next operation until
the paper has been removed.
Printer Cover Sensors
Receipt section
❏
Paper roll cover open sensor:
• When a paper roll is selected as the print sheet, if the sensor detects a cover open during
printing, the printer goes offline, stops printing immediately, and the ERROR LED
blinks. Even if the cover is closed, the ERROR LED still blinks. You need to transmit the
DLE ENQ
command to recover.
If the printer continues printing, it starts printing from the beginning of the line where
an error occurred; therefore, double printing or printing position shift may occur. It is
recommended to clear the buffers and resend the print data.
• When a slip is selected as the print sheet, if the sensor detects a cover open during
printing, the printer finishes printing data for the line when the cover open is detected,
then stops the carriage movement and goes offline. The printer goes online when the
cover is closed and restarts printing.
Note:
Whether the cover is open or not does not affect the status reported by the paper roll end sensor.
When the printer is in the waiting status, the printer mechanism is initialized if the cover is opened
and closed. Do not open/close the cover during printing, which may cause an error. Be sure not to
open the cover during autocutter operation, which may damage the printer.
❏
Unit cover open sensor:
• When the sensor detects a unit cover open during printing, the printer goes offline
depending on the setting of bit 8 for the memory switch.
The default is that the printer finishes printing data for the line when the cover open is
detected and stops printing. The printer goes online when the cover is closed and
restarts printing.
If a recoverable error is selected by memory switch, the printer goes offline, stops
printing immediately and the ERROR LED blinks. Even if the cover is closed, the
ERROR LED still blinks. You need to transmit the
DLE ENQ
command to recover. If the
printer continues printing, it starts printing from the beginning of the line where an
error occurred. In this case, double printing or printing position shift may occur. It is
recommended to clear the buffers and resend the print data.