Specifications

1-10 General Information
Confidential
When using original paper
When you use the original paper such as P350 (F380), we recommend setting the DIP switch as
shown in the table below. The setting differs depending on each paper specification. See the
Other Qualified Suppliers for Thermal Paper section later in this chapter.
Changing the DIP Switch Settings
If you need to change settings, follow the steps below to make your changes:
CAUTION:
Turn off the power while removing the DIP switch cover to prevent an electric short,
which can damage the printer.
Use a Phillips (crosshead) screwdriver to remove the screw holding the DIP switch cover.
1. Make sure the printer is turned off.
2. Remove the screw from the DIP switch cover. Then take off the DIP switch cover.
Original paper type
DIP SW2
Print density
level34
P350 (F380) ON ON 1
PD160R, AF50KS-E, P310, P300 OFF OFF 2
DIP switch
cover