Specifications

1-18 General Information Rev. A
1.5.4.3 Paper Specifications
Note:Paper must not be pasted to the paper roll spool.
When paper other than that specified is used, the thermal print head may be worn out.Be sure to use the
specified paper.
Depending on each paper specification, it is recommended to set the DIP switch as shown in Table below:
Paper type: Specified thermal paper
Form: Paper roll
Paper width: 79.5
±
0.5 mm (3.13"
±
0.02")
Paper roll size: Roll diameter: Maximum 83 mm (3.27 in.)
Take-up paper roll width: 80+0.0/-1.0 mm (3.15+0.02/-0.04 in.)
Specified paper
(see Chapter 1 more
details):
Specified thermal roll paper, NTP080-80
In Japan: Nakagawa, Seisakujo
In USA: Nakagawa Mfg. (USA) Inc.
In Europe: Nakagawa Mfg. (Europe) GmbH
In Southeast Asia: N.A.K. Mfg. (Malaysia) SDN BHD
[Original paper: TF50KS-E Nippon Paper Industries Co.,Ltd.]
The following paper can be used instead of the specified paper
above:
Original paper: PD 160R (Oji Paper Mfg. Co. Ltd.)
Original paper: AF50KS-E (Jujo Thermal Oy (Finland))
Original paper: P350(F380), P310, P300
(Kanzaki Specialty Papers, Inc. (U.S.A.))
Paper roll spool diameter: Inside: 12 mm (.47") Outside: 18 mm (.71")
Original paper type DIP SW2 Print
density
level
34
P350 (F380) ON ON 1
PD160R, AF50KS-E,
P310, P300
OFF OFF 2