Specifications

Chapter 3 Application Development Information
91
3
Receipt Enhancement Information Print Mode
You can confirm the following information on the roll paper by running the R/E information
mode:
•Automatic top logo setting
•Automatic bottom logo setting
•Extended settings for automatic top/bottom logo
Starting the R/E information print mode
Follow the steps below to run this mode.
1
Install the roll paper.
2
Close all covers and the receipt unit.
3
While pressing the Feed button, turn the power on. (Keep pressing the
button until the printer starts printing.)
The printer starts printing the current status of the printer.
When the printer finishes printing the printer status, the following message is printed and
the Paper LED flashes. (The printer is now in the self-test wait mode.):
“Select Modes by pressing Feed button.
Continue SELF-TEST: Less than 1 second
Mode Selection : 1 second or more”
4
Press the Feed button. (Keep pressing the button until the printer starts
printing.)
The printer starts printing instructions.
5
After the printing has been completed, press the Feed button twice.
6
Press the Feed button again. (Keep pressing the button until the printer
starts printing.)
The printer starts printing the R/E information.
Turn the power off and on to return to the normal mode.
With the Ethernet interface, before printing starts, it takes 6 seconds if the IP address is
fixed and 13 seconds if the IP address is obtained with the automatic setting. (It may take
longer, depending on the response time from the host.)