Specifications

Chapter 2 Setup

Receipt print speed

Selectable from levels 1 to 13 (Slow ∼ Fast) (initial setting: level 13)

Command execution during offline

When this function is enabled, you can execute specified commands even if the printer is offline

due to specified causes.

•Enabled

•Disabled (initial setting)

Power supply unit capacity

Selectable from levels 1 to 3 (Low ∼ High) (initial setting: level 3)

Autocutting at roll paper cover close

•Cuts

•Does not cut (initial setting)

Automatic paper reduction

•Extra upper space reduction: disabled (initial setting) or enabled

•Extra lower space reduction: disabled (initial setting) or enabled

•Line space reduction rate: not reduced (initial setting), 25%, 50%, or 75%

•Line feed reduction rate: not reduced (initial setting), 25%, 50%, or 75%

•Barcode height reduction rate: not reduced (initial setting), 25%, 50%, or 75%

Print density in multi-tone printing

Selectable from levels 1 to 13 (70% ∼ 130%) (initial setting: level 7)

Depending on the paper type, it is recommended to set the print density for the best print

quality.

Depending on print conditions, such as print duty, print head temperature, and data

transmission speed, print speed is automatically adjusted, which may cause white lines due

to intermittent print (the motor sometimes stops). To avoid this, keep the print speed

constant by setting it lower, or set the transmission speed higher for the serial interface.

(See "Transmission Speed (DIP Switches 1-7/1-8)" on page 46.)

For the combination of the offline causes and executable commands, see the ESC/POS

Application Programming Guide.