Specifications

46
For Serial Interface
DIP Switch Bank 1
Transmission Speed (DIP Switches 1-7/1-8)
bps: bits per second
* When DIP switches 1-7 and 1-8 are set to OFF, the value (initially 38400) can be set to any of the
values listed in the lower portion of the row using a command, memory switch setting mode, or
the TM-H6000IV Utility. (See "Setting the Memory Switches/Receipt Enhancement" on page 65.)
SW Function ON OFF
Initial
setting
1-1 Data reception error Ignored Prints “?” OFF
1-2 Receive buffer capacity 45 bytes 4 KB OFF
1-3 Handshaking XON/XOFF DTR/DSR OFF
1-4 Word length 7 bits 8 bits OFF
1-5 Parity check Yes No OFF
1-6 Parity selection Even Odd OFF
1-7
Transmission speed selections
See the “ Transmission Speed (DIP Switches
1-7/1-8)” table below.
ON
1-8 OFF
Transmission speed (bps: bits per second) SW 1-7 SW 1-8
4800 ON ON
9600 OFF ON
19200 (initial setting) ON OFF
Setting with the memory switch*:
2400, 4800, 9600, 19200, 38400 (initial setting), 57600, 115200
OFF OFF
Depending on print conditions, such as print duty, print head temperature, and data
transmission speed, print speed is automatically adjusted, which can cause white lines due
to intermittent print (the motor sometimes stops). To avoid this, set the transmission speed
higher or keep the print speed constant by setting it lower. (See "Setting the Memory
Switches/Receipt Enhancement" on page 65.)