Specifications

Chapter 1 Product Overview
29
1
• The slip paper must be flat, without curls or wrinkles, especially at the top edges.
• When using slip paper with a glued area, choose it carefully, since paper feeding is
affected by gluing conditions, such as position and dimension.
• Use thinner paper (N30 or equivalent) between the top and bottom sheets of multi-ply
paper. If thick paper is used, the copy capability is lowered.
• Do not use paper that has holes, or is translucent at the BOF sensor position.
• Do not use paper that has holes or dark positions with low reflection (less than 40%
reflection) on the front at the TOF sensor position.
• Do not use paper that has holes or dark positions with low reflection (less than 40%
reflection) on the back at the validation sensor (only for the validation models).
OK to use Use carefully Use carefully Use carefully
Paper inserting direction
Glued area
40
20
10
Paper inserting
direction
Area where holes are
prohibited and reflection
rate on the front should be
40% or more.
[units: mm (All the numeric values are typical.)]
Paper inserting
direction
Area where holes are
prohibited and reflection
rate on the front should be
40% or more.
7
20
[units: mm (All the numeric values are typical.)]