Specifications

Confidential
SHEET
67
NO.
SHEET
REVISION
I
TITLE
NEXT
68
TM-H5000II
IIII
II series
Specification
(STANDARD)
3.3.3.2 Parallel interface specification
Table 3.3.5 DIP Switch 1
SW Function ON OFF
1 Automatic line feed Always enabled Always disabled
2 Receive buffer capacity 45 bytes 4K bytes
3 Selects paper sensors to output
paper-end signals (default value of
ESC c 3)
Disabled Paper roll end
sensor enabled,
Paper roll near-end
sensor enabled
4-8 Undefined --- ---
Table 3.3.6 DIP Switch 2
SW Function ON OFF
1 Handshaking (BUSY condition)
Receive buffer full Offline or receive
buffer full
2 Internal use (Do not change settings) --- Fixed to Off
3 Refer to Table 3.3.7
4
Selects print density / Low power
consumption mode
5-7 Internal use (Do not change settings) --- Fixed to Off
8 I/F pin 31 reset signal
(Do not change settings)
Fixed to On ---
Table 3.3.7 DIP Switch 2-3 and 2-4
Level Function SW 2-3 SW 2-4
-- Low power consumption mode ON ON
1
Print density (normal) OFF OFF
2 ON OFF
3 Print density (dark) OFF ON
NOTES: • Changes in DIP switch settings (excluding switch 2-8, interface reset signal) are
recognized only when the printer power is turned on or when the printer is reset by
using the interface. If the DIP switch setting is changed after the printer power is
turned on, the change does not take effect until the printer is turned on again or is
reset.
• If DIP switch 2-8 is turned on while the printer power is on, the printer may be reset,
depending on the signal state. Do not change DIP switches while the printer power
is on.
J