Specifications

CONFIDENTIAL

SHEET

NO.

SHEET

REVISION

TITLE

TM-H5000II

IIII

II series

Specification

(STANDARD)

2.2.3 Drawer Kick-out Connector (Modular Connector)

The pulse specified by ESC p or DLE DC4 is output to this connector. The host can confirm the

status of the input signal by using the DLE EOT, GS r, or GS a (ASB) commands.

1) Pin assignments: Refer to Table 2.2.2

2) Connector model: Printer side: MOLEX 52065-6615 or equivalent

User side: 6-position 6-contact (RJ12 telephone jack)

Table 2.2.2 Drawer Kick-out Connector Pin Assignments

Pin Number Signal Name Direction

1 Frame GND —

2 Drawer kick-out drive signal 1 Output

3 Drawer open/close signal Input

4 +24 V —

5 Drawer kick-out drive signal 2 Output

6 Signal GND —

+24 V is output through pin 4 when the power is turned on. However, pin 4 must be used only

for the drawer.

Figure 2.2.4 Drawer Kick-out Connector

3) Drawer kick-out drive signal

Output signal: Output voltage: Approximately 24 V

Output current: 1 A or less

CAUTION: To avoid an overcurrent, the resistance of the drawer kick-out solenoid must be 24

Ω or more.

Output waveform: Outputs the waveforms in Figure 2.2.5 to the points A and B

in Figure 2.2.6.

t1 (ON time) and t2 (OFF time) are specified by ESC p or

DLE DC4.