Specifications

Confidential
SHEET
12
NO.
SHEET
REVISION
I
TITLE
TM-H5000II
IIII
II series
Specification
(STANDARD)
NEXT
13
1.2.3 Autocutter
Partial cut: Cutting with one point left uncut
NOTE: To prevent dot displacement, after cutting, paper must be fed approximately 1 mm
{14/360"} or more before printing.
1.2.4 Paper Roll Supply Device Section
1) Supply method: Drop-in paper roll
2) Near-end sensor
a) Detection method: Microswitch
b) Paper roll spool diameter: Inside: 12 mm {.47"}
Outside: 18 mm {.71"}
c) Near-end adjustment: Adjusting screw
d) Remaining amount: Fixed position #1 (approximately 23 mm {0.9"})
#2 (approximately 27 mm {1.06"}
(The adjusting screw has two positions.)
Refer to Appendix D.
3) Paper roll end detection
a) Detection method: Reflective photo sensor
NOTE: You can use a command to stop printing upon detection of a paper near-end.
1.2.5 Paper Specifications
1) Paper type: Specified thermal paper
2) Form: Paper roll
3) Paper width: 79.5 ± 0.5 mm {3.13" ± 0.02"}
4) Paper roll size: Roll diameter: Maximum 83 mm {3.27"}
Takeup paper roll width: 80 ±
10
00
.
.
mm
{3.15" ±
004
0 020
."
."
}
5) Specified paper: Specified thermal roll paper, NTP080-80
In Japan: Nakagawa, Seisakujo
In U.S.A.: Nakagawa Mfg. (USA) Inc.
In Europe: Nakagawa Mfg. (Europe) GmbH
In Southeast Asia: N.A.K. Mfg. (Malaysia) SDN BHD
[Original paper: TF50KS-E Nippon Paper Industries Co.,Ltd.]
The following paper can be used instead of the specified
paper above:
Original paper: PD 160R
(Oji Paper Mfg. Co.,Ltd.)
Original paper: TP60KS-F1
(Nippon Paper Industries Co.,Ltd.)
Original paper: AF50KS-E
(Jujo Thermal Oy (Finland))
Original paper: P350(F380), P310, P300
(Kanzaki Specialty Papers, Inc. (U.S.A.))
6) Paper roll spool diameter: Inside: 12 mm {.47"}
Outside: 18 mm {.71"}
NOTE: Paper must not be pasted to the paper roll spool.