Specifications

Confidential
2
SHEET
App. 2
NO.
SHEET
REVISION
I
TITLE
NEXT
App. 3
TM-H5000II
IIII
II series
Specification
(STANDARD)
4) Because the TM-H5000II is a line printer, it automatically feeds paper after printing the data.
Therefore, when the line spacing for one line is set to a smaller value than the print data,
paper may be fed more than the set amount just to print the data.
For example, when the line spacing for one line is set to 10 dots (10/180 inches) and only
paper feeding is executed, paper is fed for 10 dots; however, if bit-image characters are
printed, paper is fed for 24 dots. (Refer to Table A.1.)
When only rotated characters are printed on one line, paper feeding is executed as shown in
Table A.1.
Table A.1 Paper Feeding Amount
Required Paper Feeding Amount (dots)
Normal Font A
24 × number of times enlarged vertically
Characters Font B
17 × number of times enlarged vertically
Kanji font
24 × number of times enlarged vertically
Rotated Font A
12 × number of times enlarged vertically
Characters Font B
9 × number of times enlarged vertically
Kanji font
24 × number of times enlarged vertically
Bit image 24
5) When the printer goes to the standby (data-waiting) state during printing, it temporarily stops
printing and feeding paper. When data is transmitted and printing is executed, paper may
shift 1 to 3 dots from the print starting position, which especially affects bit-image printing.
6) Interval of auto-cutting operation in the receipt section:
For driving the autocutter of the receipt section, take the interval as a minimum of 10 lines of
printing or paper feeding (to prevent small pieces of cut paper from dropping into the
autocutter).