Specifications
Confidential
SHEET
203
NO.
SHEET
REVISION
I
TITLE
TM-H5000II
IIII
II series
Specification
(STANDARD)
NEXT
204
• The check waiting status continues until: a check is inserted, the waiting state is
cancelled, the waiting time t1 set by ESC f elapses, or the power is turned off.
When check waiting state is cancelled, or when the wait time elapses, the printer
ends reading abnormally. The printer starts reading when a personal check is
inserted.
• When all reading waveform are recognized as the specified data, the printer ends
reading normally. Otherwise, the printer ends reading abnormally.
• When the printer ends reading normally, it transmits “header + reading status
(normal end) + data + NULL” to the host computer. In other cases, it transmits
“header + reading status + NULL” to the host computer. It is also possible to add
[detailed information + separation flag] after a reading status with the FS ( f.
Header: Either one of the following can be specified with the FS ( f.
Header consists of one byte (Hex = 5FH / Decimal = 95) or Header
consists of two bytes with flag (Hex = 37H + 2AH / Decimal = 55 + 42),
specified with the FS ( f.
NUL: Hex = 00H / Decimal = 0
Data reading status:
Bit Off/On Hex Decimal Function
0,1 Readable fonts. See the table below.
2 - 00 0 Undefined
3 Off 00 0 Without detailed information
On 08 8 With detailed information
4 On 10 16 Rereading not possible. Fixed to On.
5 Off 00 0 Reading normal.
On 20 32 Reading not normal.
6 On 40 64 Not used. Fixed to On.
7 Off 00 0 Not used. Fixed to Off.
Readable Fonts
Hex Decimal Font
00 0 E13B
01 1 CMC7
02 2 Undefined
03 3 Undefined
Bits 0 and 1: Identified character fonts. When bit 5 is 1 (abnormal end), either bit 0 or 1 has no
meaning.
Bit 3: When the detailed information is specified to add with the FS ( f, the printer sets bit
3 = 1.