Specifications

Confidential
SHEET
200
NO.
SHEET
REVISION
I
TITLE
TM-H5000II
IIII
II series
Specification
(STANDARD)
NEXT
201
• When n = 1 or 49, the command specifies whether the detailed information for
the reading result is added or not.
Bit Off/On Hex Decimal Status
1 Off 00 0 Adds detailed information
On 01 1 Does not add detailed information
2 Off 00 0 Reserved.
3 Off 00 0 Reserved.
4 Off 00 0 Reserved.
5 Off 00 0 Reserved.
6 Off 00 0 Reserved.
7 Off 00 0 Reserved.
Set Hex = 00 / Decimal = 0 for the reserved bit(s).
• When n = 2 or 50, the command specifies whether the MICR function is disabled
or not if an error has occurred.
n Function
0, 48 The MICR function is disabled if an error has occurred under the
condition that the MICR function is set to disable if an error has
occurred without addition of the reading data.
1, 49 The MICR function is continuously enabled after the reading result
has been transmitted under the condition that the MICR function is
set to disable due to the following causes.
• The check whose size is out of the specified range is inserted.
• The magnetic waveform cannot be detected.
• The character which cannot be recognized is detected.
• An error has detected when the noise is observed.
• When n = 3 or 51, the command specifies the header of the transmitted data.
m Function
0, 48 The header is set as follows:
Hexadecimal = 5FH
Decimal = 95
1, 49 The header (one byte) is added with a flag (one byte) as follows:
1st byte: Hexadecimal = 37H / Decimal = 55
2nd byte: Hexadecimal = 2AH / Decimal = 42
[Details] • This command does not execute to read the check paper.
• This command affects the process of the FS a 0.
• When the printer processes the characters which cannot be recognized, the
status of the reading result becomes ‘Error Ending’.